Lub coaxiality ntawm lub nozzle tawm qhov thiab lub laser beam yog ib qho tseem ceeb ntawm kev cuam tshuam qhov zoo ntawm kev txiav. Yog tias lub nozzle thiab lub laser tsis coaxial, nws yuav cuam tshuam rau qhov tsis sib xws ntawm qhov txiav. Hauv qhov xwm txheej hnyav, lub laser yuav ua rau lub taub hau kub thiab kub hnyiab.
Kev npaj
Dimming cov kauj ruam
Yog hais tias lub hom phiaj ntawm lub taub hau laser tsis tau teem rau 0 ntawm kev khiav hauj lwm software, hloov lub laser tawg zog mus rau 100 feem pua.
2. Replacement of 1.5mm diameter nozzle
3. Attach to the nozzle plane with scotch tape
4. Click the laser shot button and release it immediately
5. Remove the tape and check the imprint, be careful not to turn the direction, there is a circle with the size of the aperture on the imprint, observe if the light spot is in the exact center of the nozzle circle
6. If the light spot is not in the center of the nozzle circle, you need to adjust the position of the light spot by rotating the left and right screws with the Allen wrench until the light spot moves to the center of the circle
7. Adjust it according to the corresponding position of the light spot and the circle
8. After repeated testing and adjustment, the coaxiality adjustment operation is completed until the light spot moves to the center of the circle.
